Installing Safety Sensors on Cincinnati Garage Doors

Do you have small children at your home? Do you have a residential garage door? If you answered yes to both of these questions you should make sure that you have a garage door safety sensor installed in your home. A safety sensor is a photoelectric eye that has an invisible laser beam across the garage opening. If someone or something were to cross this sensor while the door is trying to close, it will stop the descent and go back to the open position. If your garage door type does not already have a safety sensor here are a few steps that any do-it-yourself enthusiast could follow.

Step 1: Make sure you know where you should be installing the sensor eye. Most are installed approximately five feet off of the ground. Each particular type of system has a certain height it must be installed at for it to work correctly so make sure to read the directions before the garage door service.

Step 2: If you already have a garage door safety sensor in place and are just replacing it, make sure to turn all of the power off. You will want to ensure that you are removing the original sensors carefully so that you can possibly use the same mountings for the new sensors. Also, if the power is on you risk electrocution; so make sure that all electricity going to your garage door is off by unplugging it.

Step 3: Now you may install the safety sensors. The most important thing here is to make sure that they are carefully aligned. You will firstly want to place them where you think they should be. Do not tighten them in just yet in case you need to move them. You should then test them to make sure that they are in the correct place. Once you think they are properly aligned, you may then tighten the sensors in to the wall.

Step 4: Once you have tightened the sensors into place, you should test them with an object. Yes, you should have tested them to make sure they were properly aligned, but not you want to test them to make sure they actually work. Make sure you have plugged everything back in so there is power to the garage door again. Then stand on either side of the door. Then try closing your garage door. Once it starts moving either wave a broom or some other object in the line of the sensor. If it reopens the door then you have successfully installed a garage door safety sensor.

Cincinnati Garage Door Articles

Installing Safety Sensors on Cincinnati Garage Doors